T/CCMA 0198-2024 高原隧道电动工程机械用动力电池电性能要求及实验室试验方法

ICS53.100

CCSP97

团体标准

T/CCMA0198—2024

高原隧道电动工程机械用动力电池

电性能要求及实验室试验方法

Powerbatteryofelectricconstructionmachineryforplateautunnel

electricalperformancerequirementsandlaboratorytestmethods

2024⁃06⁃28发布2024⁃07⁃01实施

中国工程机械工业协会发布

中国标准出版社出版

T/CCMA0198—2024

目次

前言··························································································································Ⅲ

1范围·······················································································································1

2规范性引用文件········································································································1

3术语和定义··············································································································1

4缩略语和符号···········································································································2

5要求·······················································································································3

6试验方法·················································································································5

7检验规则···············································································································14

附录A（资料性）电池单体测试记录表············································································15

附录B（资料性）电池包或系统测试记录表······································································19

参考文献····················································································································21

Ⅰ

T/CCMA0198—2024

前言

本文件按照GB/T1.1—2020《标准化工作导则第1部分：标准化文件的结构和起草规则》的规

定起草。

请注意本文件的某些内容可能涉及专利。本文件的发布机构不承担识别专利的责任。

本文件由中国工程机械工业协会提出并归口。

本文件由中国工程机械工业协会双碳标准化技术委员会、中国工程机械工业协会双碳工作委员会

组织制定。

本文件起草单位：江苏徐工工程机械研究院有限公司、宁德时代新能源科技股份有限公司、中联重

科股份有限公司、深圳市比亚迪锂电池有限公司、雷沃重工集团有限公司、中机科（北京）车辆检测工程

研究院有限公司。

本文件主要起草人：肖鹏辉、司发库、刘延斌、赖庆、蒙小行、郭春华、范晓兰、孙清心、陈光旭、余智勇、

敖志勇。

Ⅲ

T/CCMA0198—2024

高原隧道电动工程机械用动力电池

电性能要求及实验室试验方法

1范围

本文件规定了高原隧道电动工程机械用动力电池单体、电池包或系统的电性能要求，描述了实验

室试验方法，确立了检验规则。

本文件适用于高原隧道电动工程机械用动力锂离子电池的生产和检验，其他类型动力蓄电池可参

照执行。

2规范性引用文件

下列文件中的内容通过文中的规范性引用而构成本文件必不可少的条款。其中，注日期的引用文

件，仅该日期对应的版本适用于本文件；不注日期的引用文件，其最新版本（包括所有的修改单）适用于

本文件。

GB/T21153—2007土方机械尺寸、性能和参数的单位与测量准确度

GB38031—2020电动汽车用动力蓄电池安全要求

3术语和定义

GB38031—2020界定的以及下列术语和定义适用于本文件。

3.1

高原隧道环境plateautunnelenvironment

满足高原地区隧道以下条件的隧道施工环境：

——非爆炸性；

——环境温度为-30℃~45℃；

——海拔为2000m~5000m；

——相对湿度小于或等于95%。

3.2

高原隧道电动工程机械plateautunnelelectricconstructionmachinery；PTECM

适应于在高原隧道环境（3.1）施工的电动液压挖掘机、装载机、凿岩台车等。

3.3

电池单体secondarycell

将化学能与电能进行相互转换的基本单元装置。

注：通常包括电极、隔膜、电解质、外壳和端子，并被设计成可充电。

[来源：GB38031—2020，3.1]

3.4

电池包batterypack

具有从外部获得电能并可对外输出电能的单元。

注：通常包括电池单体、电池管理模块（不含BCU）、电池箱及相应附件（冷却部件、连接线缆等）。

1